Standard strobe Landing lights. Using top quality LEDs. These lamps give a quick double flash just like real aircraft strobe lights.
This kit comes with the standard strobe kit plus an amplifier module and an addtional two HI-Flux state of the art LEDs. All four LED's can be used together, or just the HI-Flux. They still give the impressive double flash.
These modules use a complex flash, to mimic a rotating lamp. They are available with diffrent colour and size LEDs.
These lamps appear to rotate and come in a number of colours . The lamp is approx 18mm diameter & 12mm high. They are hand made, so dimensions may alter slightly.
These LEDs have been picked for there quality,Brightness and colour. They come with a fitted resistor and the leads are twisted pair, 800mm long. (ideal for the Amplifier module or by themselves - continuous ).
These LEDs have been picked for there quality,Brightness and colour. They come with a fitted resistor and the leads are twisted pair 800mm long.(ideal for the Amplifier module or by themselves - continuous ).
Seven high quality, high brightness, 3mm leds, Only require the leds to be fitted to the helicopter and a PP3 battery fitted (battery not included). The LEDs are :
GREEN
RED
WHITE
DOUBLE STROBING WHITE
FLASHING RED (1)
FLASHING RED (2)
FLASHING YELLOW
.JPG)
This kit contains: 1 HIFLUX Led, 1 resistor, 500mm of twisted pair wire, shrink sleeve to suit & instructions. ( Note : the 350mA version resistor gets very hot and the life expectancy of the led may be reduced,, if used continuously ).
Note : the resistor will get warm, so must be mounted in a heat resistant vented area.
This kit contains: 1 module, 1 HIFLUX Led, 300mm twisted pair wires & instructions.
This is a 15 degree lens and holder. 20mm diameter.
.JPG)
Long Blade Micro Switch for use with spare servo to switch on lights etc.
.JPG)
This is a Multimode - Multispeed - two opposed output flasher module supplied with two ultrabright leds.
This module will connect to a flasher module, and allow the flasher module to be expanded to operate 8 Hiflux leds @ 350mA 12 v or 30 Hiflux leds @ 12v or 120 Standard format leds @ 25mA. Total. It has two channels that can be connected to one or two inputs. More Amplifiers can be used on the same input. Each led MUST have an appropriate Resistor. The module can be used from 5v to 30v (hiflux leds are recommended to be run @ 12v). See our led range.
